Development of power plants in the application of titanium tube medical titanium plate

Power generation equipment, particularly the lower temperature side of the heat cycle , titanium provides an ideal environment. Around 1957 , Cotton and Downing in the paper first raised the titanium and titanium alloys issue publicly , they estimate the seawater corrosion resistance of titanium in flowing seawater , the corrosion rate of 1250 to 1 meter. They are also out in this paper, titanium has a higher resistance to corrosion / erosion resistance in seawater , in the wet steam also has a high resistance to erosion , this discourse has been widely recognized .
    Since titanium tube having such properties, it has long been considered a special type which is used as a surface condenser tubes plant to cool the steam discharged from the steam turbine generator . By the late 1950s and early 1960s, it was the titanium tube sample is mounted on industrial test using sea water cooled condenser , a few years titanium bar supplier later when some of the tubes draw checks can immediately see the good applicability of titanium . A large number of experiments show that : once the sediments dry adhesion on titanium surface is removed from the original gold gangrene year's pattern is clearly visible , undetectable corrosion scene, but these are all non- administered drill pipe , they cost more than than the copper alloy tube much higher. When the welded pipe into the market, it was immediately recognized as applicable to the condenser. Welded titanium tube again as a test sample degassing installed on the condenser section and auxiliary titanium industrial bar equipment. In 1972 , the first combined all titanium pipe manufacturing power generation equipment with a condenser and finally put into operation. Then , the rapid increase in nuclear power condenser and thermal power plants a wide amount .